ONEUP SWITCH SRAM DM - Etoile SWITH GXP / BB30 Long spindle OneUp

Name: ONEUP SWITCH SRAM DM - Etoile SWITH GXP / BB30 Long spindle
Brand: OneUp
SKU: 366440

€ 10,99

- 8 %

~~€ 11,99~~

Richtprijs € 29,99

ONEUP SWITCH SRAM DM - Etoile SWITH GXP / BB30 Long spindle

€ 10,99 ~~€ 11,99~~

Verkocht door Alltricks

Levering vanaf woensdag

Nog maar 4 op voorraad!

Word Alltricks+

1 jaar lang voordelen voor € 9.99

Voor maar € 9.99, geniet van 1 jaar gevuld met voordelen:

Gratis onbeperkte leveringen het hele jaar lang

Kortingen via terugbetalingen op duizenden producten

100 dagen om van mening te veranderen

Exclusieve voordelen

Meer weten over Alltricks+

Het Alltricks+ abonnement wordt niet automatisch verlengd, er hoeft niet betaald te worden als het afloopt.

Omschrijving

Switch was developed to reduce the cost of replacement chainrings, increase compatibility with new offsets and to make the process of changing your chainring much faster and simpler.

Cheaper Replacement Cost - Replacement rings are a fraction of the cost of a complete direct mount chainring
Quick Change - Replace your ring in less than an minute, using only a 4mm hex key. Tailor your gearing to the terrain that you're riding
Enduro World Series Champion Winning Narrow Wide tooth profile keeps your chain in place on the roughest terrain
Get ultimate traction with Oval rings by smoothing out the torque you deliver to your rear tire

Quick Change

Rings can be replaced in less than a minute with only a 4mm allen key, without removing your crank. Simply loosen the bolts 2 turns, unlock the ring by rotating it by 20 degrees and pull it over and off your crank. Reverse these steps to install your new ring. If you plan to ride a trail that you know is steeper than your local trails, you can switch to a smaller ring in the parking lot, in less time than it takes your friend to put on his riding shoes!

Features :

Material : 7075-T6
Chainline : Non Boost (49mm)
Compatible Sram (XX1 / XO1 / X1 / GX)
Compatible GXP / BB30 long spindle
Référence : 1C0376BLK

Installation: Align the small bump on the edge of the carrier with your crank arm. Install ring onto carrier and tighten bolts to 8Nm. All 4 bolts need to be backed off / tightened to Switch rings (anti-clockwise is tightening from the outside / on bike position). Use some grease on the Switch bolts and tightening with a wrench FULLY ENGAGED in the bolt.